The 3.5kw competition series amplifier is a 3,500 watt mono block. It is capable of running up to 18 volts
for up to 5,100 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept 0 awg for power and
0 awg for ground.
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
We recommend for installation
• 1 upgraded battery under the hood
• 1 extra battery in the rear
• Minimum of one 0 awg ran from the front battery to the rear battery
• Upgraded aftermarket alternator
• Dash mounted voltage meter
Features | Voltage | 3.5kw | |
Output Power (RMS) | 4 ohm | 14.4V | 750W x 1 |
2 ohm | 1,800W x 1 | ||
1 ohm | 3,500W x 1 | ||
1 ohm | 16V | 4,000W x 1 | |
1 ohm | 18V | 5,100Wx1 | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 300 Amps | ||
Linked Fuse Rating | 600 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | Yes | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga | |
Heatsink Length | inch/mm | 21.26"/540mm | |
Heatsink Width | inch/mm | 9.38"/238mm | |
Heatsink Height | inch/mm | 2.35"/59.6mm |
FAQ
We always reccomend a big 3 kit for every vehicle, regardless of the system. However, if you plan on running more than 1,500 watts we reccomend a good AGM battery underhood, and then from there more power will need more electrical upgrades depending on power.